Electric Water Heater Repair in Frisco, TX
Most electric water heater faults are a burned-out heating element, a failed thermostat, or a tripped high-limit reset button. All three are repairable, and the tank usually is not the problem.
Call for a price(972) 945-6903
Price guide: A heating element typically runs $175 to $400 and a thermostat $150 to $350, parts and labour. Many visits replace both elements and thermostats at once, which costs less than doing them one at a time.
These are typical prices for the Frisco area, to help you plan. Every home is a little different, so your price is confirmed with you before any work starts.
What the visit involves
A standard electric tank has two elements, upper and lower, each with its own thermostat. The plumber turns the power off at the breaker, tests each element and thermostat with a meter, and checks the wiring and the high-limit switch. The tank is drained to swap an element, then refilled before the power goes back on: an element that heats without water around it burns out in seconds.
What the symptoms tell you
- No hot water at all: a tripped breaker, a tripped reset button, or a failed upper element or thermostat. The upper element heats first, so when it fails, nothing heats.
- Hot water runs out fast: usually the lower element has failed, so only the top of the tank heats.
- Lukewarm water: a thermostat set too low, a failing element, or a broken dip tube mixing cold water into the hot.
- Reset button keeps tripping: a thermostat stuck on, a shorted element or a loose wire. Pressing it again does not fix the cause.
Before you call
Check the breaker for the water heater in the panel. It is a double breaker, usually 30 amps. If it has tripped, reset it once. If it trips again, leave it off and call. You can also try the red reset button behind the upper access panel, but only with the breaker off first, because the terminals behind the cover are live at 240 volts.
Thinking of a heat pump water heater?
If your electric tank is old, a heat pump water heater uses a fraction of the electricity of a standard one, and federal tax credits have covered part of the cost in recent years. It needs room and air around it, and it gives off cool air, so a garage usually suits it better than a closet. See water heater replacement.
Helpful answers
Questions people ask
Why is my electric water heater not heating?
The usual causes are a tripped breaker, a tripped high-limit reset button, or a failed upper heating element or thermostat. If the reset button keeps tripping, there is an underlying fault to fix.
How much does it cost to replace a water heater element?
Typically $175 to $400 for one element, parts and labour. Replacing both elements, or an element and thermostat together, usually costs less than two separate visits.
Why does my hot water run out so fast?
On an electric tank, the lower element has often failed, so only the top third of the tank heats. Sediment and a broken dip tube can also cut the hot water you get.
How long do electric water heaters last?
Usually 10 to 15 years for the tank. Elements and thermostats can fail sooner and are replaceable.
Related
Cities we cover around Frisco
- Electric Water Heater Repair in Prosper
- Electric Water Heater Repair in Little Elm
- Electric Water Heater Repair in The Colony
- Electric Water Heater Repair in Plano
- Electric Water Heater Repair in McKinney
- Electric Water Heater Repair in Allen
- Electric Water Heater Repair in Celina
- Electric Water Heater Repair in Lewisville
- Electric Water Heater Repair in Carrollton
- Electric Water Heater Repair in Addison
- Electric Water Heater Repair in Lucas
- Electric Water Heater Repair in Fairview
- Electric Water Heater Repair in Richardson
- Electric Water Heater Repair in Murphy
- Electric Water Heater Repair in Coppell
- Electric Water Heater Repair in Flower Mound
- Electric Water Heater Repair in Highland Village
Also covered: Hackberry, Oak Point, Cross Roads, Aubrey, Parker.