Tankless Water Heater Repair and Installation in Frisco, TX

Most tankless water heater problems in North Texas come down to scale. Hard water leaves mineral deposits in the heat exchanger, and the unit throws an error code, short-cycles or stops heating. A descale every year prevents most of it.

Illustrative photo of a plumber descaling a wall-mounted tankless water heater

Call for a price(972) 945-6903

Price guide: A tankless descale and filter clean typically runs $150 to $300. Repairs such as a flame sensor, igniter or flow sensor usually fall between $200 and $600. A new gas tankless unit replacing a gas tank typically runs $3,500 to $6,500 installed, more if the gas line or venting has to change.

These are typical prices for the Frisco area, to help you plan. Every home is a little different, so your price is confirmed with you before any work starts.

What the visit involves

For a repair, the plumber reads the error code and the unit's history, then checks gas pressure, venting, the inlet filter and the flow sensor. Many calls end with a descale: the water is shut off at the isolation valves, a pump circulates descaling solution through the heat exchanger for about an hour, and the filter is cleaned.

For a new install, the gas line is sized for the unit, which usually needs more gas than a tank, and new venting goes in. Isolation valves are fitted so the unit can be descaled later. A switch from tank to tankless usually takes most of a day.

Common tankless problems

Why North Texas water is hard on tankless heaters

The cities around Frisco get their water from North Texas lakes, and it is moderately hard. When hard water is heated, calcium and magnesium come out as scale. In a tank it falls to the bottom as sediment. In a tankless unit it coats the narrow passages of the heat exchanger, which cuts heating and makes the unit work harder.

Manufacturers generally call for descaling once a year in hard water, and skipping it can affect the warranty. A water softener slows scale down but does not stop the need to flush.

Is tankless worth it?

Tankless suits a busy household that runs out of hot water, or a home where space matters. The trade-offs: the install costs more than a tank, the unit needs a yearly descale, and the hot water can take a little longer to reach the tap. Gas tankless units save on gas mainly because they do not keep a tank hot all day. How much you save depends on how much hot water you use.

Not sure? See tank vs tankless water heaters for a side-by-side.

Helpful answers

Questions people ask

How often should a tankless water heater be descaled?

Once a year in North Texas hard water, or as the manufacturer's manual says. Homes with a water softener can sometimes go longer, but the inlet filter should still be cleaned every year.

Why does my tankless water heater keep going cold?

The usual causes are scale in the heat exchanger, a dirty inlet filter, a tap opened too little to reach the minimum flow, or a gas line too small for the unit. An error code on the display usually narrows it down.

How much does a tankless water heater cost to install in Frisco?

A gas tankless unit replacing a gas tank typically runs $3,500 to $6,500 installed. A larger gas line or new venting can add $500 to $1,500 or more.

How long do tankless water heaters last?

Often 20 years or more with a yearly descale, about twice as long as a tank. Skipping the descale is the most common reason they fail early.

Related

Cities we cover around Frisco

Also covered: Hackberry, Oak Point, Cross Roads, Aubrey, Parker.

Ask for a call back